Home

General Introduction Of Small Roller Brush Trimming Machine With Foot Switch WXD-TM500

1) This trimming machine WXD-TM500 is used to trim the filament-ends of those small industrial roller brushes, so as to keep all the filament-ends flat and neat. The maximum size of roller brush it can process is 500mm (Length) x 150mm (Diameter). A machine in other size range could be customized.

2) The operation is very simple and easy.

Operator just needs to step on the foot switch to start trimming. After trimming each roller brush, it automatically stops to let operator take out the finished brush.

3) It's equipped with automatic vacuum cleaner, which helps keep the workshop clean.

4) Those trimming blades are made of imported steel with excellent tenacity, which are abrasion-resistant. The blades could rotate in both clockwise and counterclockwise directions, which are controlled by the switches installed aside. Please bear in mind that operator should put nothing on the blades before they start rotating.

5) This WXD-TM500 is used to trim those small roller brushes with filaments made from PP, PVC, PET, nylon, pig bristles, horse hair, tampico, etc, please note that the diameter of a single filament should not be thicker than 2.0mm.

6) Please be informed that it is not allowed to trim brushes with stainless steel wires, copper wires or abrasive wires.

Technical Parameter of Small Industrial Roller Brush Trimming Machine WXD-TM500

1) The maximum size of roller brush processed: 500mm (Length) x 150mm (Diameter)

2) Power Input: 0.55KW 

3) Voltage: 380V, ±10% is allowed 

4) Motor Rotation: 1400RMP 

5) Rated Frequency: 50Hz 

6) Specification: 90cm(Length) * 40cm(Width) * 60cm(Height) 

7) Daily Continuous Working Time: 24Hours 

8) Gross Weight: 50KGS 

9) Packing: Wooden Case

Notice:

1) Before running this small roller brush trimming machine WXD-TM500, please check whether all the working parts are installed correctly and firmly. 

2) After switching it on, operator should wait for a moment until the blades start rotating regularly.

Maintenance Of Small Roller Brush Trimming Machine WXD-TM500

1) Operator should keep this roller brush trimming machine clean, and often spray the blades with anti-rust agent. 

2) If the blades become blunt, please smear the blades with diamond paste, and then switch it on to make the blades rotate in counterclockwise direction for 5 to 10 minutes. Please note that diamond paste should be wiped out thoroughly after grinding.

3) Operator should regularly check each part of this roller brush trimming machine to see whether there are loose screws or not, and please make sure to tighten it if he finds a loose one, so as to avoid any accident.

4) If this roller brush trimming machine is always deposited in a humid environment, please check whether there is leakage of electricity around the motor before usage. If operator feels leakage of electricity, please make sure to dry it thoroughly before running, so as to keep safe.