Home

Which Brushes Can WXD-3A2H08 Make?

General Introduction of Dualpurpose 3-Axis 2-Head Integrated Machine For Making Plank Brushes & Disk Brushes WXD-3A2H08

1) Welcome to take a look at our latest machine model WXD-3A2H08, which is a dualpurpose 3-axis 2-head machine, it's able to make two kinds of industrial brushes: both plank brushes and disk brushes. Isn't it really a cost-effective machine for a small-scaled manufacturer?

2) When making a plank brush, it drills holes and tufts filaments synchronously, or, it can also drill holes firstly and tuft filaments secondly, which is adjusted and controlled by operator.

When making a disk brush, it drills holes firstly and tufts filaments secondly. Please note that all the holes and filaments are made vertical at 90 degrees only, they can't be tilting at different angles.

3) The maximum size of plank brush allowed is 1500mm (Length) x 1500mm (Width); the maximum outer diameter of disk brush allowed is 400mm. A machine in other bigger or smaller size could be customized.

4) The maximum length of filaments (outside holes) allowed is 110mm. (If you need a machine to make industrial brushes with much longer filaments, such as 180mm filaments or 260mm filaments, no problem, absolutely we are able to customize another machine exactly according to your requirements)

5) If you are not sure whether this dualpurpose machine is the best choice for you, or if you just have some other questions about this dualpurpose machine, please do not hesitate to contact us at chloe@brushmachine1.com or just leave a message on this page, we'll do our best to get back to you with a professional solution at the earliest.

Technical Parameters of Dualpurpose 3-Axis 2-Head Integrated Brush For Making Plank Brushes & Disk Brushes WXD-3A2H08

Maintenance of Dualpurpose Integrated Machine For Making Plank Brushes & Disk Brushes WXD-3A2H08

1) Operator should often add lubrication oil to the working parts of this dualpurpose brush making machine, so as to decrease abrasion.

2) Operator should regularly check each part to see whether there is a loose screw, and please make sure to tighten it, if he finds a loose one.

3) Please keep guide rails and ballscrews clean, and make sure that there is no scrap sticking on them, so as not to decrease the precision.

4) Be sure that the electric box works under ventilative conditions; do not put this dualpurpose industrial brush making machine under humid or high-temperature conditions; do not shake the electric box.

5) Please keep electric box far away from magnetic field, otherwise it will be probably out of control.

6) Be sure that all cables connect correctly. Red, blue and yellow cables connect with three-phase 380V wires, green cable connects with neutral wire, yellow-green cable connects with earth wire. Plugs are numbered as "1, 2, 3, 4 , 5", "1, 2, 3" are for 3-phase 380V wires, "4" is for neutral wire, "5" is for earth wire.

7) The working voltage should be stable, around AC380±10V; over-voltage will probably cause the ruin of electronics.

8) Do not knock at the touchable screen with hard articles, otherwise it'll decrease its sensibility or even break the screen. Do not drag wires rudely, either.

9) Please note that there is high-voltage electricity inside electric box. If it is out of order, only professional technicians are allowed to check and dismantle it. Non-professionals are prohibited to dismantle it, so as to avoid getting an electric shock and the ruin of data.